Services · CAE / FEA

Engineering Analysis

We define load cases and boundary conditions, analyse critical areas and turn findings into design decisions. The analysis scope follows the product’s operating conditions and acceptance criteria.

Discuss your project ↗

Mechanical component with mesh, load conditions and an illustrative stress distribution — Illustrative CAE visualisation

Typical needs

Identifying structural risk before prototyping
Balancing weight and strength targets
Validating design decisions around critical regions

Inputs for analysis

CAD geometry or an existing technical model
Material properties and connection definitions
Load cases, operating conditions and support constraints
Acceptance criteria and technical objectives to validate

Scope of service

We carry out structural analysis alongside design development. Geometry, materials, load cases and technical objectives determine the analysis method.

Structural strength, stress and deformation assessment

Definition of handling, lifting and operating loads

Static, modal, fatigue and buckling analysis as required by scope

Assessment of connections and welded structures

Checks of mesh quality, assumptions and boundary conditions

Assessment of safety factors and critical areas

Weight optimisation and design revision recommendations

Delivery approach

Inputs and objectives

We clarify geometry, material properties, operating conditions and acceptance criteria.

Analysis model

We define geometry simplification, connections, loads and boundary conditions.

Solution and checks

We check mesh quality and assumptions, then solve the defined scenarios.

Results assessment

We compare stresses, deformation and critical areas against technical objectives.

Report and revision

We deliver assumptions, findings and design recommendations, and assess revisions within scope.

Typical deliverables

Methods and technical capabilities

Analysis assumptions and load casesResult plots and critical-region assessmentSafety and deformation summaryDesign improvement recommendations

Frequently asked questions

What inputs are needed?

Geometry, material data, boundary conditions, load scenarios and acceptance criteria are defined together.

Can the design be revised after analysis?

Depending on scope, revision recommendations or updated design data can be prepared for critical areas.

Dynacore

Have a technical requirement?

Let us define the scope, deliverables and the right engineering workflow together.